Snowfall
- NoahSnowNew
model
land_surface
noah
The density and depth of freshly fallen snow in WRF's unified Noah land-surface model, SUBROUTINE SNOW_NEW of phys/module_sf_noahlsm.F (WRF 4.8, sf_surface_physics = 2): how much depth a step's snowfall occupies, and what it does to the density of the pack it lands on. THE PHYSICS, IN TWO PARTS. First, how dense the falling snow is: Gottlib's (1980) fit makes it a floor plus a 3/2 power of how far the air is above -15 C, so warm snow falls denser (0.077 at -8.7 C, 0.122 at -2.9 C over this reference set) and cold snow is capped at the floor. Second, how it combines with what is already there: the water equivalent newsn expands into a physical depth hnewc = newsn/dsnew, that depth is ADDED to the pack, and the new density is the DEPTH-WEIGHTED average of old and new -- the only combination that conserves depth times density, i.e. water. Because fresh snow is always lighter than a settled pack, a snowfall step always lowers the mean density, and SNOWPACK's compaction then works against that. The two routines are the pack's density budget between them, which is why this component is authored beside `snow_compaction.esm` and shares its constants. WHAT IT DOES NOT DO. It does not add the water equivalent -- SFLX does that (`SNEQV = SNEQV + SN_NEW`) before calling -- so this component conserves nothing on its own and is not a closed budget. Nor does it decide WHETHER it runs: SFLX calls it only when SNOWNG (frozen precipitation) or FRZGRA (freezing rain onto a sub-freezing surface), and the guard belongs to the caller. That guard is load-bearing here in a way it is not for most routines, because this component is the identity at newsn = 0 ONLY while the pack is thicker than par.snow_new_hmin; below that WRF's degenerate-average branch would RAISE the density to the fresh-snow value out of nothing. A consumer must therefore reproduce the guard rather than mount this unconditionally, and `thin_pack` reports when it would matter. THE REFERENCE STEP IS THE LARGEST AVAILABLE, for the reason FORTRAN_BUGS N99 states as a rule and this is the second Noah component to meet. Nothing here is recovered by differencing -- both outputs are published where they form, at full magnitude -- so there is no cancellation floor pushing the step down. Meanwhile newsn is proportional to the step, so the fresh layer's weight in the density average is too: 0.0010 to 0.13 at WRF's own 60 s step, and about 2e-11 of that at 1e-6 s. A smaller step would leave a rel 1e-9 assertion testing nothing at all. So the reference is the 60 s replay pass. NOT TRANSCRIBED: nothing. SNOW_NEW has no UA_PHYS branch and no options; the whole routine is here.